Description
Our most aggressive compound in a 150 ml bottle — heavy cutting power for deep defects, with finish quality good enough for a heavy one-step.
Heavy Cut V.2 pairs PROGRESS ABRASIVE | LOW TEMP technologies: a wide abrasive range inside a highly lubricated, cool-running paste.
- Clears deep scratches, “sandblasting”, bird-dropping and insect etching
- Enormous cutting power, yet an optimal finish quality
- Often completes an aggressive One Step in a single pass
- Heat-dissipating base protects the paint and eases handling
- Works on wool, foam and corduroy | denim discs, rotary or DA
Cut: heavy · Finish: optimal gloss · Best for: heavy one-step correction
Read the full story
The 150 ml format is the sensible way into the top of the SWAG POLISHING range — the same uncompromising Heavy Cut V.2 that studios use for the worst paint they see: deep scratch fields, etching from bird droppings and insects, dulling and “sandblasting”.
Two technologies do the work. PROGRESS ABRASIVE mixes particles across a wide range of abrasiveness so the cut stays strong and even through the whole set. LOW TEMP surrounds them with high lubrication that helps dissipate heat, lowering the risk of overheating the paint and making the machine easier to guide over the bodywork. The paste performs identically on wool, foam or corduroy-and-denim-type discs — full abrasive potential regardless of technique — and still leaves a finish clean enough that many corrections stop after this single stage.
How to use
- Shake well. Work in the shade on cool, clean paint.
- A few drops onto a cutting pad — match pad hardness to the damage.
- Polish a 40 × 40 cm section with moderate pressure until the paste is worked in — rotary up to 1,500 rpm, DA as preferred.
- Degrease with SWAG Final Inspect, inspect, and repeat if defects remain.
Give hot panels time to cool before you continue.
Capacity: 150 ml · Technology: PROGRESS ABRASIVE | LOW TEMP · Machines: rotary & DA · Made in Poland — in-house recipe
Reviews
There are no reviews yet.